Load your ATV or side-by-side with “No Doubt”

A hitch-mounted folding ramp system built to load ATVs and side-by-sides into a pickup, flatbed, or trailer. Steadier than loose ramps, and one person can do it.

📞 Call 308-655-0249 💬 Text

Call for pricingAdjustable-width plate on every set

▶ Loading an ATV

How it works

Set up in three steps

Slide it in. The frame drops into your receiver hitch and pins in place.

Set the ramps. Unfold the ramps and set the width for your machine.

Load and go. Drive up, then fold the ramps or pull one pin to store them.

See it in the field

Built for real farm & ranch use

Darren’s ramps, out where they work.

Hitch-mounted ramps deployed off a flatbed truck — Hitch-mounted, deployed off a flatbed

Side-by-side loaded on a flatbed with ramps deployed — Side-by-side on a flatbed

Truck with an ATV loaded, out in a field — Loaded and ready in the field

ATV loaded on a flatbed with the folding ramps beside — ATV loaded, ramps fold up beside

Why “No Doubt”

Steadier loading, less hassle

✔Hitch-mounted, not loose. The frame slides into your receiver hitch, so it stays put and is built to reduce the sliding you get with loose ramps.
✔Adjusts to many setups. The adjustable-height upright works with most pickups and flatbeds, and you can load from the back or the side.
✔Side-by-sides too. The aluminum ramps slide wider by loosening four bolts.
✔Folds up, one pin. Pull a single pin to remove; folds flat in the bed, flatbed, or trailer.
✔One-person setup. Lightweight enough for one person to position, fold, and pull the pin.

The story behind it

Built by a farmer, after seeing the worst

Hi, this is Darren Huxoll, founder and designer of “No Doubt” ATV Safety Ramps. I designed the first set nearly 20 years ago, after watching loose ramps slip under two farmers I knew, and after a close call of my own where a ramp slid out from under me. I wanted a system that stayed attached to the vehicle, adjusted for different setups, and folded away without a pile of straps and loose parts.

“I’ve used this design for nearly 20 years. It stays attached to the vehicle, folds up quickly, and has made loading a whole lot less of a hassle for us.”Darren Huxoll, founder

Hand-built at Big D Welding. Darren Esch builds every set one at a time, cutting and welding each ramp by hand, with no factory or assembly line. If you need a specific tweak, he can do that too. Darren Huxoll designed the system, and he is who answers your calls and texts.

Will it fit my setup?

Contact Darren to confirm fit for your specific ATV, mower, side-by-side, pickup, flatbed, or trailer. Every set includes the adjustable-width plate.

Reduces ramp movement

The hitch-mounted design is built to reduce ramp movement and sliding compared with loose ramps. Always follow safe loading practices and make sure your equipment is properly secured.

Made to order

Hand-made by Big D Welding, one set at a time, built when you order. Reach out and Darren will talk through your setup.

Call for pricing

Ramps are hand-made in limited batches. Reach out and Darren will walk through what fits your rig.

📞 Call 308-655-0249 💬 Text Darren

Not ready to call?

Send a few details

Darren will get back to you. (Draft form, not connected yet.)